Asus EAH4850 1024 problem

[K88]

Hello,

if I run 3dmark, my monitor turns off after 1 Test. Even when games often turns from the monitor,the problem also occurs when my monitor in power saving mode. Only a reboot will help there. The system is running but, as far as I can judge, continue. Why?

i Have the latest drivers on it and the current bios update.

Remaining system.

2 Phenom X4 920
Arctic Cooling Alpine 64 PWM (Fan) --
4096MB Corsair PC2-800 CL5 TWIN2X4096-6400C5
Gigabyte GA-MA78GM-S2H
PSU: BeQuiet 450W

[kiLLer]

The Setup your entering, is the BIOS, do you know which BIOS you are using? Is it an Award Bios, AMI Bios, Phoenix, etc?

Should say at the top of the screen somewhere, when you enter it, one of those names...

Beep codes can be interpretted differently depending on the Bios manufacturer.

[K88]

Ok, has not achieved anything. But I have found:

The system will also depend (at least, says the clock on my G15 motherboard).

[ApPy10]

hi,
you can map out the Temperature? Loading times GPU-Z and log down the temp while playing, 3D Mark.

Enable VPU Recover times in Catalyst Control Center may prevent the moniter to turn off, then it's definitely on the map.