Canon PIXMA MX310 All-In-One Printer Mx310 ink absorber

**Mattabesic** · 07-06-2010

I have purchased the Canon PIXMA MX310 All-In-One Printer some time before which was working all fine but now it having the problem in printing and copying. The Canon PIXMA MX310 All-In-One Printer Mx310 ink absorber is showing that it is full and unable to print and copy. So help me the issue to get my printer working.

**Gonzo** · 07-06-2010

As per your discussion it seems that your device that you are using is having the waste ink and it need to get serviced so that it can work properly. The printer should get serviced on a definite interval of time so that it will work all fine. So you should also give a service to the printer and see whether you are getting same issue or not.

**Simond** · 07-06-2010

I think that there might be some of the issue with the printer cartridge which is not properly connected or having the malfunction. So it is better to check whether the cartridge is properly connected not. Also if it is not working then replace the cartridge with the new one and check whether it is working or not. Hope this will help.

**Mattabesic** · 07-06-2010

Originally Posted by Simond

I think that there might be some of the issue with the printer cartridge which is not properly connected or having the malfunction. So it is better to check whether the cartridge is properly connected not. Also if it is not working then replace the cartridge with the new one and check whether it is working or not. Hope this will help.

I have tried the both the thing that is discussed but let me tell you that after performing the same i am unable to get my printer working for me and still having the same issue. Is there any thing else that can help me for this issue?

**Simond** · 07-06-2010

In that case i will advise you to take the help of the Cannon which might help you with the issue. Cannon support team might be aware of the issue and can fix the problem for free if printer is under the warranty period. So it is better to contact them and take the help from them. Hope that you will get the proper solution. Also let me know about the solution which you got from there.

**Lambard** · 08-06-2010

I am having a trick by which you can work with the issue that you are going through so it is better to go with the same. I hope it will work for you.

Power off the Canon printer.
Hold Stop/Reset and hold the power button for 5 sec
Keep holding the power button and release Stop/Reset button.
Press two times Stop/Reset button
Leave Power button
Wait till you get the lights
Press the Stop/Reset button 3 time each having the 3 sec gap
Check whether you are getting the orange light or not.
Press Power button and enter the data
Now Remove the Cartridge
Now Leave it 20 sec
Press the Power Button and shut down printer
After that Start the printer
Set the language and Country

**Mattabesic** · 09-06-2010

Originally Posted by Lambard

I am having a trick by which you can work with the issue that you are going through so it is better to go with the same. I hope it will work for you.

Power off the Canon printer.
Hold Stop/Reset and hold the power button for 5 sec
Keep holding the power button and release Stop/Reset button.
Press two times Stop/Reset button
Leave Power button
Wait till you get the lights
Press the Stop/Reset button 3 time each having the 3 sec gap
Check whether you are getting the orange light or not.
Press Power button and enter the data
Now Remove the Cartridge
Now Leave it 20 sec
Press the Power Button and shut down printer
After that Start the printer
Set the language and Country

Thanks Lambard. I have tried this and now the problem of mine got resolved without having any further issue. Now i can get the printer working properly.