EK Mosfet Waterblock and Asus 4870X2

**CodGuru** · 01-04-2009

Here I have a little problem with my graphics card (Asus 4870X2), since I have added a EK Mosfet Waterblock - Acetal, I can not start my pc. In fact, it starts but nothing appears on screen (black screen).

On the motherboard (Asus Maximus II formula) are all light green, so OK. I tried to make a Clear Cmos, but without success.

Is this what you ever? I have not yet had the opportunity to test the card on another config, but for now I do not see the reason.

**revolucioncg** · 01-04-2009

When you have finished installing the block, at first boot, you notice something else without making really care? Style type a short circuit? The monoblock while copper requires to make the installation, the copper being max driver, just nothing to burn the graphics card

Otherwise, make sure that your well PCIe connect the two, that the graphics card is in port (it happens).

**CodGuru** · 01-04-2009

No, actually, the first time I mounted the waterblock, everything was working perfectly for about 1 week.

Then later, I repeat modify my Watercooling, I completely disassembled and reassembled after all, I had this problem.

This is not a problem of power supply because the red LED is not lit. I already had this problem due to a usb device that prevented the pc started, but no device is plugged ...