How to re-enable ZoneAlarm 9.2.106

**Vascon!cell** · 17-02-2012

I am using Dell Inspiron 5150 laptop and I am running Windows XP on the same, I have recently installed ZoneAlarm 9.2.106 and there was a need to temporarily disable ZoneAlarm and I had done the same by un-checking "Load ZoneAlarm at startup" but then now when I am trying to enable the ZoneAlarm after clicking on the program icon the program is appearing to be loading but then the icon keeps on saying "Protection is up, UI is initializing" and I am not able to re-enable the ZoneAlarm. Is there anyone who can help??

**Badrinath** · 17-02-2012

I am using Dell Inspiron 5150 laptop and I am running Windows XP on the same, I have recently installed ZoneAlarm 9.2.106 and there was a need to temporarily disable ZoneAlarm and I had done the same by un-checking "Load ZoneAlarm at startup" but then now when I am trying to enable the ZoneAlarm after clicking on the program icon the program is appearing to be loading but then the icon keeps on saying "Protection is up, UI is initializing" and I am not able to re-enable the ZoneAlarm. Is there anyone who can help??

I think that you should better upgrade to the current supported version of ZoneAlarm 10.1.065.000 rather than using ZoneAlarm 9.2.106 but then before doing the same make sure that you are uninstalling the previous version completely, if you want then you can try to use appremover tool or other uninstalling tool that you find good, after uninstalling the same reinstall the current supported version of ZoneAlarm 10.1.065.000 from the below link:

Zonealarm free 10.1.065.000

**Vascon!cell** · 17-02-2012

I have tried out doing the same a number of times but then it was not helping and that is the reason that I have switched back to ZoneAlarm 9.2.106, I also wanted to know if there is a way by which I can force the ZoneAlarm UI to finish the loading without a reboot??? Is that possible?? Any further help for the same will be appreciated.

**Zared** · 17-02-2012

I will like to inform you that there is no way by which you can force the ZoneAlarm UI to finish the loading without a reboot by now and the problem that you are facing is appearing to be because of conflict, I mean that there might be some other security tool that might be blocking the Zone Alarm free and might be not allowing it to run properly as well, just check out and see if there is any such security tool in your case that might appear suspicious.