How to flash bios on Foxconn N15235

[Popeyee]

Hi, I have a Foxconn N15235 motherboard. I have try power it on but it keeps rebooting. It contains BIOS 794F1P03 version with INTEL CORE2 DUO E8400 CPU and 2GB CRUCIAL RAM. I never done any overclocking task on it and it also not gives overheating problem. Due to rebooting problem, i need to flash this motherboard bios. How can i do this flashing on it?? Any suggestions welcome to flash this motherboard bios.

[Geniee]

Most of the time, such rebooting happens because of the power supply. hence Try another PSU of equal/higher wattage. may be you found better result. Most cases, internal thermal sensors react quicker than the infusion to the heat sink and hence machine starts rebooting contiguously. Hence try this changing PSU and check output. If your system runs well, please don’t flash BIOS. After all, there is risk when flash BIOS. It works to avoid future problem.

[Quasim]

If that didn't work on your foxconn motherboard, you need to flash your motherboard bios. Before doing such flash bios on your Foxconn N15235 remember few things on it. Check foxconn motherboard jumper/BIOS for BIOS Flash protection. If you found such jumper, first disable it. without disabling this jumper you can't flash bios of your foxconn motherboard.

[Ramona19]

Yes, there is necessary to first disable this jumper. then only we can simply flash our motherboard bios. Without it flash bios not goes in right direction. Follow below steps for flash your motherboard bios.

• First download and extract the bios version that you want onto this motherboard. extract it in external storage device.
• Boot your system and connect bootable device to motherboard.
• After getting the A:\ prompt, go to that bios version setup file directory using cd command.
• then in that drive, use below command.
  

  AWDFLASH 683f1p48.bin /py/sn/cc/cd/cp/wb

• Again type “AWDFLASH /?” command. it start flash process.
• finally press f1 to restart your computer.
• That's it.

[Skullnit]

This is really helpful process to flash the bios of the motherboard. while it can be also possible with the AMI Flash BIOS Procedure. In above process you need to simply replace the first command to the AFUDOS BIOS file /P /B /C /N <enter>. Remaining command almost same. It works similar way and you foun the correct flash output on your motherboard.