Intel DG33TL memory upgrade

**Alibamu** · 09-10-2010

I have buy 2 DDR2 sticks individually each with 2GB capacity and same speed 667MHz to upgrade my system memory from original 2GB to total 6GB. The original RAMs do not appear to work at all. If I place them in with the new 2GB they are just not seen below the properties of my computer system or in BIOS, and if I set them single the computer system will not set up at all. I am wary to place the identical RAMs in the similar DIMM of channels C & D as I am thought to. Why my new RAM sticks are not working? Does anyone have idea related to this topic, may can any help me. Any support would be really respected. Thanks in Advance.

**Balamani** · 09-10-2010

I came to your problem what you have with your system, but I didn’t exactly get it problem properly. Can you give me the exact specification of your new memory sticks which you have taken for the upgradation? I just want to go through that by which I can able to give the proper information about what problem you are facing with your computer system.

**Alibamu** · 09-10-2010

I have taken the memory sticks for upgrading my computer the specification of the memory sticks is shown below.

Product Description- AUM DDR2 PC5300 2GB 667Mhz DESKTOP RAM
Storage Capacity- 2GB
Technology- DDR2 SDRAM
Form Factor- LONG DIMM
Memory Speed-667MHz
Chip Configuration-256x4 16C
Voltage-1.8V
Low Density- No (HIGH DENSITY)

**Balamani** · 09-10-2010

I tried to observe if there is anything I should alter in BIOS but was not able to figure it out. I think that I have to go with your system configuration for that can you give me the system configuration what you are using at present. For making the proper suggestion such that your problem must be removed out.

**Alibamu** · 09-10-2010

The computer system which I am using is six month back configuration. The specification is very simple as I have taken. The configuration is shown below.