Unable to boot with my new config

[revolucioncg]

I just got up a new config:

DFI Lanparty JR P45-T2RS Motherboard
C2D E7300
ATI HD4870 GSE
Antec Neo HE 430W

And Vista blocks systematically just before arriving in the office

I thought it came from my psu, perhaps too just for the HD4870 but it works perfectly on my old config (AMD X2 3800 + @ 2.6GHz)

Moreover, it seems to me that the C2D consumes less and after the different topic, 430w seem sufficient for such a config

I have tried unsuccessfully to launch vista impossible or even to reinstall (even on another HDD), it systematically plant

If you have any ideas, then please help me.

[Terrextre]

Have you tried in safe mode (if it exists on Vista)? Have you recovered a former hard drive of an Old config with Vista or above as you do a fresh installation (format)?

[revolucioncg]

Can't boot in Safe Mode!

I used the disk of the old config after having transfer just the drivers of the former motherboard, but I also tried to install Vista on a new HDD to boot from CD, without success, have returned after crash the CD key (sometimes even before)

I also tried to replace the hd4870 with my 8800GTS but the same problem

[Terrextre]

Well, in all cases a fresh installation with formatting is required.

I understand that you get a boot on your vista CD, with your old hard drive, but you can not install everything before crash and it's the same with a new hard drive ...

as you do when formatting your new facilities?

[Alexisus]

check the voltages of the ram in bios, 2.0 or 2.1 volts
timings 4 4 4 12

[revolucioncg]

I tested, and it worked! I can't believe this!