Info: Deathadder USB Device Not Recognized

[Beryl]

Hi all, I purchased the mouse before two months and getting some issues related to detection if the device, I am unable to solve if you all have any suggestion regarding this then please let me know what should I do in this situation . Actually , it got started properly but after some time it automatically got stopped working. It says that it is unable to detect the mouse, what would be the reason for such issue ? The error is as : 'USB Device Not Recognized'

[Killen]

You know when you get this error message, then you should be aware about that your Deathadder has been destroyed completely and It's as easy as that. I don't think, there is any fiix for such issue , you only can do one thing and that is replacement just call to deathadder manufacturer and replace the device .It happens with less number of users and I was also included in the list .

Before getting this error,Wheel light glows but razer logo does come to be flash much more. System not going to boot and when the mouse is connected in or connected with the any system, it pops up with the following message "USB Device Not Recognized"

[T.J.]

There are some reason behind this error and it happens just because of some causes, I figured out some reason that are as follows and can be helpful for you to resolve this issue by yourself. When working with the drivers v1.05 and firmware 1.21:

DPI configurations and Polling rate configured in the drivers, Changing profiles with the button inside the mouse, Wrong flashing of firmware (to a lesser degree - it primarily causes some more issues in order to this)

[New ID]

I also purchased the deathadder Just before a week and first and i tested it in the internet cafe . It was working very fine and then I connected it with my computer system. It was not going properly with winxp default mouse drivers that was expected the after I installed the razer drivers that I downloaded from the official site of the manufacturer. Issue get started in the middle of installation and says that Windows logo confirmation dialogue should appear and installer got FAILED continue the installation procedure . Then I restarted the system again and tried to open the installed drivers which suggested that "No mouse detected!".

I replaced the mouse from manufacturer and then again tested it in a internet cafe and played cs whole day and then I connected it to my home PC and same thing going on again with second mouse. I am working with windows xp pro (32-bit). What should be the issue ???

[Rawko]

According to your description of the error there is something going wrong with your installed operating, it is not capable to do all this because as you stated that you played CS whole day with the first mouse and second mouse also and working ver fine without installation of proper device driver, you need to check the mouse with another system again and if going on well then you need to move for the formatting of system and install OS with the new OS backup..

[Fabian]

There are so many causes and suggestion is given below that can be helpful for you to find out the most USB issues with USB portable external disks and related devices

There are something need to find out but suppose USB and Windows for different interfaces / OSs like mac and Linux equal steps may be adapted to suit.

1. Just be that it is plugged directly to the system to a USB 2.0 port not a USB 1.0 port as it can have effects on flexibility
2. You should be run with only the cables are specially issues with it to you, don't go for entire USB cables are similar even though they should be.
3. You should not plug it via an external USB HUB.