Hi all,
Recently my computer hosts the most obvious sense of heat than before, I clean the dust inside, or after hot power supply was found to be hot, Actually i am using Asus 5850, Can anybody suggest me what is the issue with changing the volts.
Hi all,
Recently my computer hosts the most obvious sense of heat than before, I clean the dust inside, or after hot power supply was found to be hot, Actually i am using Asus 5850, Can anybody suggest me what is the issue with changing the volts.
It may be overload may be the power to run the bar. Have you recently added hardware. Like graphics may be it would increase the power load Or may supply their own cooling system is broken. Check the fan broken. You can be sent to the warranty. You need to view the fan is turning, whether the power cord off, if the problem is not damage power supply.
The power supply circuit board may be a fault occurs, there may be power failures, power failure is not what you said is only an expression of a failure mainly depends. You can also check with buy a transformer, to buy time to show you how much power is, for example, the desktop is usually 350 watts. General electronic products now support wide voltage 110v-240v you want to see if it is the mark, if there is no need to buy transformer, directly on it.
Basically, the computer power supply will support switching 120/240v There is only one very small number of power. I personally do not recommend you use the converter because in addition to voltage different from the Not the same power frequency. Asus is the mainland is 50Hz 60Hz So I suggest you see your computer's power supply is to provide a voltage range of 120 ~ 240v or switch.
if you have auxiliary motherboard power connector, now the new motherboards out generally, a majority of the old no. Auxiliary power connector 4-pin generally. Do not have power, but now all have 4-pin auxiliary power interfaces. I recommend it to you a number of sections. CoolerMaster (Coolermaster) Tomahawk 320W Or Glands (AcBel) Smart 350. Check that and reply.
You need to check the values with a multimeter test the voltage should be within the scope of your spread equal to 220V ± 10%. Test round when the core Department put red pen, black ink to put the edge of a cylindrical metal.The host computer to connect the power cord directly to each road test with a multimeter can be of,If the pass is good. Check that and reply.
Bookmarks