How to repair hard drive spindle motor

[Abbie]

Hi,
My hard drive has stopped working suddenly. I had checked it properly. When run the system the hard drive starts and the motor inside that stop suddenly after some time. That shows that the motor of the drive is failed. How to make that work. Can it is possible for me to repair this disk physically. What are the tools needed for that and what is the procedure for the replacement.

[deoWo]

The motor inside the harddrive or spindle is also called as spindle shaft. This is responsible for the rotation of disk platters inside the hard drive which operates when you work on a pc. It is the storage media where your data lies. It is reliance and consistent and can work for continuous hours. If this stops working your system crash. You cannot at your own hand can replace this. Better try to give the same to a service center.

[RoninBlade]

Many time a hard drive fails when the spindle inside the disk stop responding. But after that it is still possible to recover the data from it. By changing the motor. But the issue is that it is not really easy. The main issue here is to make the hard drive work again. This needs some advance tools and I will prefer you to show your disc to professional data recovery guys.

[Fabian]

It is first main important to determine the exact part which is used in your hard drive for replacement. This can make the hard disk work again. There are sensitive internal parts which are costly but though effective. It is very hard to repair the same from your own hand but if you try data recovery companies for them then that will make your work much easier.

[Hardwareman]

The spindle motor in a hard disk usually damaged if the platters in the drive rotates at a very high speed. This cause the spindle to damage sometimes. But replacing the motor of a hard drive is possible. I will too not say you to fix this at your own hand because by this you can loose your valuable data. But a recovery company can make this work.

[Maxforu]

The spindle attached inside a hard drive requires a current inside the coil which reverses the magnetic fields to generate and stop and start repelling. In a AC motor you can observe that this is done by supplying current in a changing direction. To make your spindle spin you have to build up a circuit which reverses the coil that depends on the sensor inside the drive.