error code 10822

[Vivan]

Hi all,

I am using Apple OS X. I getting error code 10822 when installed CS 4 later. Error Code 10822 What is the reason? How to solve it ? Please expert guidance. Thanks in advance.

[JonathanD]

This error is coming because CS4 upgrade my SN is invalid. Now blocked activate.adobe.com. Serial Number still can not successfully registered to use, with SN when there is a red underline. basically this will the Date back 08, open PS, help menu deactivate, re-open the PS will be prompted to input SN. All the best.

[Glenny]

The error is usually caused by problems by the driver, while a defective memory, damage to the virtual memory file, some software, can also cause this error. The solution is like:
1. Check the recently installed or upgraded drivers and software;
2. Test whether the memory problems;
3. Enter "Recovery Console" to virtual memory paging file Pagefile.sys the partition, the implementation of "Del Pagefile.sys" command to delete the page file; then the page file is located in the district implementation of the "Chkdsk / r" command; After the re-set into the Windows virtual memory.
4. If the Internet encountered this blue screen, then should be the network card driver problem, upgrade the driver.

[Eric B]

You need to restore the disk, the option you are looking for is under "Options". If you have already booted from the Restore DVD and started the install procedure, the Operating System will tell you that you cannot install from the DVD without changing your options.Click options and then choose Archive and Install. All the best.

[Raine]

I found this message error message 10822 implicates launchd. From my terminal, I ran 'ps auxw | grep -i launchd'. I establish that there were a few running. One run as root, and that's theoretical to be there. One (/sbin/launchd) was running as my userid and was started at about the right time. You need to restarted your system a little times while troubleshooting, so it's unlikely that this would have help you. Restarting your system would have definitely gotten clear of any spurious launchd processes. I can only deduction that something about launchd's configuration got corrupted. The reinstall would clearly fix that.

[Sam.D]

You need to put the Restore disk in the optical drive, reboot the iMac while holding down the "C" key until you see the spinning gear. It allow the installer to launch and select the Archive and Install option, preserve user settings. Follow the instructions from there and check. If you found any issue, reply me back.