NETGEAR WN802Tv2 error occurs after v3.1.1 firmware update
I have recently upgrade my WN802Tv2 with v3.1.1 firmware, but unfortunately I get the error by doing this I have try several time but have the same problems of continually getting the same error. So guys you have any ideas regarding this fatal error. I have visited several sites to overcome this issue but I still have the problems, so guys any suggestion for this will be appreciated.
re: NETGEAR WN802Tv2 error occurs after v3.1.1 firmware update
So you are using WN802Tv2, and the problems occur due to the updating of v3.1.1 firmware. And you are facing the same problems again and again then you should contact to the experts. To resolve this may be this happened that you are missing something for the complete successful process. Or you have another option you should try the same thing by using to reverse this by firmware v2.0.2.
re: NETGEAR WN802Tv2 error occurs after v3.1.1 firmware update
You can go for rebooting your WN802Tv2 as soon you have upgraded it with v3.1.1 firmware. You just check whether your firmware is corrupt because of v3.1.1 upgrade. May some time it happens that due to some application error present in the upgrading process which in result corrupts the firmware.
re: NETGEAR WN802Tv2 error occurs after v3.1.1 firmware update
If you have facing the problems then do the following steps , First you have to reboot your WN802Tv2 and after that see whether your Access Point does not showing any error or some warning message. If it shows the error then you just plug of the power of your WN802Tv2 and again start it. Now see whether you’re your Access Point is visible or not. If it is not visible then there are the problems with your Wi-Fi.
re: NETGEAR WN802Tv2 error occurs after v3.1.1 firmware update
Even I was also facing the same issue. I have try several thing and also visited several sites but not get the solution so finally I take the help of one of my friend and finally I get the solution to overcome the WN802Tv2 error. So according to my suggestion you just try this, may it help to resolve your problems too. For this you have to do this simple procedure. You just try to change your unit IP address from the default value to your preferred IP address. And again reverse back to the default IP address.
re: NETGEAR WN802Tv2 error occurs after v3.1.1 firmware update
To overcome this problems i.e. from the WN802Tv2 error , one have to change its IP address to its ideal IP address, after that he have to alter forth to its defaults that previous one IP address. So these procedures almost solve the issue.