Installing xen on HTPC server problem
Does anyone know how to force the mode and transparent PROMISC
PC under debian?
its getting this if I do
CITATION
ifconfig eth0 0.0.0.0 PROMISC
but I have to launch a mano terminal
and if I put in / etc / network / interfaces that I could find on the net
CITATION
ifconfig eth0 0.0.0.0 up PROMISC
it does not work
may be due to a problem that xen renames the bridge in eth0??
please any one knows tell me ,
thank you
Re: Installing xen on HTPC server problem
Set the network card(s) IP configuration as required for your network. To configure these settings click on the Network Interfaces heading. If your network card is not listed below the heading it is probably because it has not been detected by the kernel. If this is the case proceed with the installation without configuring a network card. You will need to install the kernel modules for your network card manually once your system is installed.
Select your network card and click on Edit.
Select the Static Address Setup radio button. Type the IP address and Subnet Mask you want to assign to the network card.
Click on the Hostname and Name Server button. The hostname and domain name fields should already be populated because we set it earlier in the install. However you can enter the name/IP address of the DNS server(s) on your network and list domains to be used for FQDN completion. Click Ok when complete.
Now click on the Routing button. On this page you can type the IP address of your default gateway. Click Ok to continue.
Once you have finished configuring your network card(s) click Next on the Network Address setup page and Next on the Network Card Configuration page.
Re: Installing xen on HTPC server problem
the problem comes from the xen script which "transformed" eth0 Petho then created a new bridge ,and suddenly at this transformation the config file is "deleted" at least not taken into account for the bridge.will therefore in one way or another anyway launch after script xern.