Overclock of P4B533-V P4 2.4

I have an ASUS P4B533-V with Bios 1009 and I want to watch Multipliers that for some reason do not get clockwise FSB over 160. I am running the Ram at 200 @ 133 ~ 241 @ 160 and it is 266Mhz ram which then would make this good, since I now have the clockwise down, and it will take it back to the default clock FSB @ 177, which I will come up in. But for some reason it stops at 160, has no problem with the temperature of some components, and I have tried to increase tensions and everything, but getting "black screen" at higher than 161FSB higher than 160 will not get to boot.

So when do I exclude RAMs, the processor comes to a halt, it is possible to achieve this in one way or another, are willing to do most to determine the potential of the processor. Had not done anything if I managed to clock it to 3.2 and got 266Mhz in the frame which I only have the 2.4, have a bad ram that can not be put down at the ram speed so it does not exceed 266Mhz before 3.2Ghz.

Has now been given up in the FSB 165, and get to boot, but I go up on 166 = 3006Mhz CPU so it will not boot windows. Now I run a 512MB Crusial Value R PC2100 266Mhz ram min at 322Mhz, to see if I get it up in the 330 = 165, but it struggles to get over 165 FSB afterwards.

Someone who knows what I should put these on:
Memory hole at 15 meters-16M Enable / Disable
Video memory cache mode UC / USWC
Dram refresh rate 15.6 us / 7.8 us

I have almost the same card here ... it manages nearly 200 FSB ... use the integrated video card? Have you locked PCI / AGP frequencies?

I put the integrated graphics card to auto that it is not going to disable, And I have locked the AGP / PCI to 66/33 and is still not over with the 165 as windows boots. and it is not stable before I go down to 2.8GHz, but it is ok if I set ram to 3:4 and not 1:1 as I have now.

But still it will not be over 165, before it was black screen but now it locks up the windows load command.

This after I put on properly refrigerated thermal paste on the chipset cooler, can alternatively put the fan on it too, but the CPU cooler and the cooler Zalman CNPS7000BCu.

Which CPU do you have? since you can optimize 200MHz FSB?

Have p4b533-e and 2.0 (20x) and a 2.4 multi northbridge ... (18x), 2.0n goes up to 2.7 + - while 2.4n go to 3-3,2 ish

Hmm really strange that I do not get a longer time, is the same bios for both cards? What bios are you using?

I use at least 1009 Beta 002.
May want to try to flash to 1008 and see how it goes.