-
New PC will not boot
Have total new PC:
ASUS RAMPAGE FORMULA x48 MB
E8500 cpu
4870X2 ASUS
4096 MB DDR2 PC2-8500 Corsair Dominator
1000W Corsair HX1000
When I try to start up there will be no signal to the screen.
All fans are running, however, fan on the graphics card at the max.
LCD lines writes 'CPU init'.
On this motherboard there are also voltage control diodes, in particular, cpu, ram, etc. There are three diodes green, yellow and red. There is normal / high / crazy-voltage. When I try to start up, lights all 3 at once. The PC has never been started. All parts are brand new. It was never been adjusted in volt settings, so I personally believe that this is just under the boot (eg self-check) all diodes lights.
What do you think it can be? Could it be the CPU, since the LCD offender mail will never go beyond 'CPU init'
-
Re: New PC will not boot
Are both plugs in the motherboard? both 24pin and 4/8pin plug?
-
Re: New PC will not boot
You dint mentioned your monitor's status, receiving electric current or not. Sometimes i occurs due to RAM problem, check your RAM, put it another slot or try another RAM. Also remove the processor and fix it again. One thing more, may be there is a problem with the data cable from CPU to monitor. If still problem exist, then you should contact your vendor.
John
-
Re: New PC will not boot
Thank you very much for that guidance John Adam. I'll go through it and check if anything works.
Page generated in 1,717,383,122.57927 seconds with 10 queries