now this is my 4th Logitech Alert camera that I have bought at my place. Already I have connected 3 cameras that are working great without causing any issue, these three cameras are working from past 1 year and recently I planned to go for the 4th one and hence somehow bought it. Connected this new 4th camera with all other 3 ones and fortunately got it fixed and also I am able to get pictures from all the four cameras and I must say that the power line signals are looking damn strong and powerful. After the 2nd day of the installation I was recommended by the commander that the new camera that I have installed needs a software update. Following the instruction I updated the required software but I was not aware that updating the software is going to cost me so much, I was into a huge mess after I performed the update, I found that only those other three cameras were able to show up the pictures whereas the 4th camera was not at all visible in the commander. When researched found that the issue was related to the missing camera which was somewhere related to the IP issue so therefore I decided to go for IP problem procedure. What exactly I did was unplugged the cameras and then unplugged the powerline bridge. After doing so I power cycle the router, when the router was activated I plugged in the powerline bridge and at last plugged the cameras one by one sequentially. Guess what? After following this lengthy procedure I found only one camera in the commander which was quite shocking, therefore I decided to go for the IP procedure once again and this time after the completion I found only 0 cameras which was even more shocking, till now I have tried out the procedure some 10 to 20 times but the result is the same, no cameras connected to the commander. Now I am really very much worried please help me out, what should I do to get everything to the normal position.
Bookmarks