unable to access to SoftX3000 by telnet in huawei

[Garlanka]

i don't know what is the exact reason for this issue. i am making a connection by means of CMDin window's interface and making TELNET to connect the miniUMG8900 by typing on the CMD: telnet X.X.X.X (UMG IP address) and then by putting the same user & password that I usually make use of in the graphics interface, but:i am a getting connection failed .what could be the possible reason behind it.

[Sasuke Uchiha]

i think you should work on some commands to try. i will possibly give one command to do so. try it.
to have a connection established as you were saying., type.
Telnet 192.168.143.4 6000
LGI: OP=”XXX”, PWD=”YYY”;
where XXX stands for user and YYY stands for the password
you will have a conenction established over it. To logout enter this command

[Anjan1990]

i think you should type the password and the user id correctly. there are problems generally when you type wrong passwords. make sure of your password and have a proper connection established. i had a similar problem but i was not having a proper connection so as a result it was failing to have a connection. hope this helps in your case.

[Nityaa]

there was a same problem in my case and after tying the commands in my CMD, I made a connection by means of telnet and it stopped in this screen:
[root @ server] # / usr / bin / telnet 172.31.224.6 6000
Trying 0.0.0.0 ...
Connected to 0.0.0.0.
Escape character is'^]'.
i don't have enough idea about the upcoming error. please sort it out for me.