want to change build in 1024x576 screen resolution into 1366x768 on my dell netbook.

[TamaraAce]

I would akin to to construct within a screen through a superior resolution than 1024x576. The touch screen I comprise at the moment works very well however I have a lot of programs than do not run through such an unusual resolution. I contact with dell, they let know me it possibly will work. However they won’t perform the build in. Has somebody experiences through it? EBay present lots of displays. So getting the hardware is not a difficulty but perform I necessitate to change whatever thing?

[Madhulika]

I consider your biggest obstruction is going to be decision a display within that resolution through the similar connector as that has been the hesitant block on top of additional Dell netbook. Even though the latest 2110 Netbook has a 1366X768 LCD, it possibly will retrofit. However aside from exchange one and demanding it, most likely no technique to tell if it will. There are no graphics cards actually; it's embedded on top of the Motherboard.

[Alejandro80]

I don't consider you'll be capable to obtain 1366 x 600, 1366 x 768, which is able to well 720p satisfactorily is a lot more ordinary. I comprise this size screen on top of my Mini 10 and it doesn't experience gimped in any way. If you had the touch screen earlier than, you necessitate the screen cover in favor of non touch screen to. I had touch screen and at the moment the latest one is regarding 2 millimeters thinner. So there`s a gap between screen and screen cover. But it is only an optical problem. I don’t really care.

[Sawan123]

I pay money for a 1366x768 screen on top of my 2100, did not have the touch screen, my 2100 does, and I obtain a razor blade and suspiciously estranged from the touch screen of the creative screen. After that place the touch screen on top of the 1366x768 screen and position it within 2100, the whole thing works faultless. I had to recalibrate the touch screen throughout the windows. 1366x768 screens I pay money for was a Dell 1012, the straight exchange through the screen 2100, exclusive of problems.

[Karleen]

I utilize a razorblade and sprint it among the two the entire technique, don’t be inquisitive it, there is a skinny piece of plastic/sticky obsession holding them mutually. Necessitate slicing that every the way approximately and it will approach right off. I just position the touch screen on top of the latest screen, no glue or whatever thing between them and it workings faultless. I did utilize a little electrical tape on the side to make confident it doesn’t shift; you can’t observe the tape at what time installed.

[Farrah]

Aero within Windows 7 does appear a bit additional sluggish at the higher resolution, however OS X acts presently as snappy as earlier as the upgrade. I disbelief I will attempt a few trickier mod on top of this and I don't would like to demand that Bliss swap the True Life display in favor of the matte version that I ordered. Those tiny connectors and cable probably won't take kindly to frequent cruelty. I possibly will try a dissimilar Windows driver from Intel to perceive if I am able to obtain some speed back, however even if that doesn't offer any benefit I am completely content to have every this acreage on my Desktop.

[Iroquois]

The new display was a straight swap by the old one. Solitary connector in definitely the same area. I run 10.6.4 on my 2100, and the just glitches are no slumber, outer VGA reflect doesn't work, and the screen is clear when OS X reaches the desktop. I get around that by having a slumber corner set up so it wakes the screen when I (aimlessly) rodent to that corner and again out. I came across I was in reality running the most cutting edge Windows showcase driver from Intel for the 945 Express chips as opposed to the Dell endorsed driver. I minimized to the Dell driver and Aero livened straight up. I'm satisfied as punch now.