Overclocking Phenom X3 II 720

[cobra2008]

I have definitely a lot of points with this Processor.

When I run cpuz, the core speed and multiplier never stop moving. The core speed oscillates between 1600MHz and 2800MHz. The multiplier can range from 4 to 26.

That seems strange. So I close, I run cpuz and occt that says cpu frequency of 800 MHz, 1600 or 2800 ...

Why it is like that?

When I use the processor bottom, it stabilizes at 2870. Apparently there is a power saving mode or something like that.

[revolucioncg]

For the change of mutliplier, it must be an option on your motherboard to disable. Your as what?

Otherwise, by default, you must be 14 x 200 and therefore at 2800 MHz. I managed to mount it stable at 16.5 x 200 without touching the vCore,
for the 4th core, from what I read, it is just a series produced in December if I followed

[Dominic8]

This is the Cool 'n' Quiet, if you want to transfer the disabled in the bios. If you want overclock must disable preference.

I got a 16x200 vCore to stock, and I am at 18x200 at 1.52v (motherboard not too made for the occasion, or to a voltage high enough)

[cobra2008]

I overclock and that moves.

@ revolucioncg: yeah, I can not activate the 4th one. (UD4-790X)

Otherwise I am very limited in spite of temperatures that increase soon. (if I have occt I can probably go up to 16 x 200 but when I bench with 3d mark => reboot. So I can only 14.5 x 200 )

[Dominic8]

I was with a full 46 degrees without touching the voltage. Now I have a cooler master hyper 212 (huge) and I'm a 20° idle and 35° for a full 1.52v. I read your concerns temperatures normally it should be like me before (other person were the same)

And 15 x 200 otherwise it goes by? Otherwise I have not tested my 4th core