Overclock a Phenom X4 II 940

[PsYcHo 1]

Hi, I just installed my Phenom X4 940 [email protected] II Ghz then I push a little (at 3.2Ghz). I need your help because I do not know enough about Overclocking. My motherboard is a DFI DK 790GX M2RS. My heatsink is a Cooler Master V8.

So, what do I need in the bios to get to this frequency?

Thank you

[lorenz]

Ideally when overclock whatsoever in a configuratiin Intel or AMD is to do through the bios of the motherboard. When you start your pc press the key del / del during the boot sequence to access the history of your bios motherboard then find when you get going in the "genie bios" you will see that this is are all the overclocking settings

[PsYcHo 1]

Normally, when you change the CPU clock ratio, your CPU frequency increases? If so, it is base 15, I put it to 16.5 but there is no change in CPU-Z it is still 15. at least that was the wrong thing I change.

[Viceman]

If you do well assured that you change the cpu ratio to increase the fsb. even if the Phenom II apparently come up with better frequency bus .logically 16.5 = 3300 mhz x200 therefore a gain of 300MHz compared to the base frequency ... apparently the rub is that under windows overclock this frequency is apparently not taken into account with you, "exit and save" to save the settings in your bios?

[.:MUNDITO:.]

The phenom II 940 overclock very well compared to the Phenom 9850!

First adjustment completely stable with my cooling system: 4 ghz permanent! 41 ° C to 47 °

Setting: 20 * 200 = 4 ghz
Voltage: 1.6 V!

Attention, without changing the source voltage 1.36 V, not to exceed 3.8 ghz