Ninja PLUS Rev.B and motherboard

[Arlo]

Hey, I just bought this cooling and an ASUS mobo. Before the page stop is nothing that my mobo was tested. so I ordered it.

Is on the side now that the Heat Pipe interference complaint. Yes my cooler encounter imot Heat Pipe on the motherboard. But the suit relies on the ground. So now the question is should I change CPU coolers?

Looking not so good, but it is so you can pipe from the CPU cooler, which collide with the cooling on the motherboard.

[SUpER CoP]

It does not matter that some of the heavy CPU cooler is in contact with the motherboard card fins. You may bend up the bottom tip of the ninja so that the pressure becomes easier, or drag fan-clip a little higher on the cooler if the fan is received.

It looks a little crowded for such a large cooler but it will probably be going well.

[Arlo]

So what do you think, it should not transfer the heat?

[SUpER CoP]

That makes it not enough when both surfaces should have a similar temperature while the air is moving in the area.