Waterhead: EK - VGA Supreme - Acetal

[beatnik_abx]

Hello.

Has looked a bit on this Cooling head for my old comp.



EK - VGA Supreme - Acetal

It is sold for a nice price, etc.
But that fell to me in the eye that it only cools the GPU.
And I know that in any case also has RAM and a MOSFET
8800GT graphics card. So what do you say?

Should then I also invest in some small coolers there?

[Omari]

I'll suggest this,



EK - FC88 GT / GTS (G92) SLI - Acetal

[lorenz]

Then buy some small cooling profiles of context and MOSFET.

For RAM:
EnzoTech BMR-C1



To ram. These are cheaper and can easily cope:
Koolance Video RAM cooling



For MOSFET:
Enzotech MOS-C1



For MOSFET. These are cheaper and can easily cope:
Swiftech MC21


The cost is obviously better, but the other is also fine for the task. For the money it comes, it may well correspond to buy a full cover cooling block to the graphics card, but this can not be used when you change graphics cards. So I think personally that the cooling solution which only cools the GPU is the best.

[beatnik_abx]

I can not buy it here,

Swiftech MC14 (Thermattach)


Also throw them on RAM and MOSFET? Will it work?

[.:MUNDITO:.]

Which also explains other, so there will just be used heatsinks. Just buy the cheap, which does fine job, but you must make sure to have a little air over the profiles.

M-Cubed double adhesive thermal paste is very good to glue them with.

[lorenz]

I can not buy it here,

Swiftech MC14 (Thermattach)


Also throw them on RAM and MOSFET? Will it work?

What exactly are those? They are also too big for MOSFET, but for context it may be used. But I think that I link them to be better.

MOSFET chips are small, so you have to be addressed in such small number I showed earlier.