Cooler installation for PC

[russ_da_buss]

Hello,

I have got two coolers for my PC but i am unaware about its installation. I want to know where to place them well as connect to the source or where?

[lorenz]

To connect them and give them energy, all depend on the connectors you include (3 or 4-pin). You can connect to the motherboard if you have free pin connector for the fan or directly to the connectors or molex connector of the power supply for fans (usually of 3-pin cable yellow, red and black) or 4-pin molex connector .. if you're missing connectors on the motherboard (Fan) you can use in cable dividers Y.

[russ_da_buss]

I appreciate your reply but i didn't get how to do that. I am not well versed in that. Connectors with cables and splitters to be applied but where? I am confused.

[lorenz]

Fans tend to keep a 3-pin connector that goes to the pin as indicated FAN on the motherboard and a four-pin, so you can connect directly to the board or a BASE molex connector from the source that has free. If your motherboard has just two connectors Fan one for the processor and one for the chassis, if you put two fans, one will go to the motherboard and the other two ends to every fan. Or one to connect the motherboard and another to the source .. whatever is good for connecting to the motherboard is for controlling the revolutions.

[russ_da_buss]

Thank you for that detailed guidance lorenz. I believe that information will help me install the coolers quiet easily. I will consult any doubts with you do i get any problems.

Thanks and greetings.

[lorenz]

Sure man. Tell how you go. Share your experience in installing