This document uses the Router-2 configuration.
In order to set up the router to allow Telnet access, issue the line vty command. This command allows for the configuration of Virtual Terminal (VTY) lines for remote console access. You can configure the router to accept one or more Telnet sessions. It is strongly suggested that you configure password checking with the login and password line configuration commands. This example configures the router to accept five sessions, with the password "letmein":
Code:
Router-2(config)#line vty 0 4
Router-2(config-line)#login
% Login disabled on line 66, until 'password' is set
% Login disabled on line 67, until 'password' is set
% Login disabled on line 68, until 'password' is set
% Login disabled on line 69, until 'password' is set
% Login disabled on line 70, until 'password' is set
Router-2(config-line)#password letmein
SOURCE: cisco.com
Bookmarks