Reset Lan to connect to the internet

[Aramax]

Hey Guys!
I have a very weird problem...! When the computer goes into sleep mode, it will not connect to the internet after waking from sleep. When i go through the diagnose and repair process, it tells me that the server was pinged and did not get any response. it then tells me to reset the lan card. Once i reset the LAN that is disable and enable it back, it works fine until it goes to sleep again. Can anyone help me??

[FaMe FacToR]

Hey there!
I had a similar issue with vista... I suggest you to update your LAN drivers. I did it and just rebooted the computer... And everything was fine then...! If this doesn't work try to install an older version of the driver of your LAN card...! All the best...!

[Aramax]

Hey guys!
I already tried to reinstall, upgrade and even degrade my drivers... but after all this everything works fine for few days and then everything is screwed up again...! Help!!

[SmirnOFF]

hey ya why don't you try this :

Click [Start] - Click [Run...] - enter: cmd, Click [OK]

At the prompt (c:\.....>) enter: ipconfig /release, press [ENTER]

At the prompt (c:\.....>) enter: ipconfig /renew, press [ENTER]

TEST: Connect to Internet.

If SUCCESS: Repeat Steps after PC Command Line on your other PCs.

If NO SUCCESS:

At the prompt (c:\.....>) enter: ipconfig /all, press [ENTER]

Ensure DHCP Enabled == YES

If IP Address == 0.0.0.0 OR 169.254.0.0 to 169.254.255.255, connect PC (wired) to router (if possible) or modem and perform ALL steps again...
All th best...!