Right now I am having Cisco 7920 and Cisco 7921 IP phones which are working quite fine.
Code:
dot11 ssid xxxxxxxxxx
vlan 57
authentication open
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption vlan 57 key 1 size 128bit 7 xxxxxxxxxxxxxxxxxxxxx transmit-key
encryption vlan 57 mode wep mandatory
!
ssid xxxxxxxxxxx
speed basic-1.0 basic-2.0 basic-5.5 basic-11.0
power local cck 50
power client 30
channel 2412
station-role root
interface Dot11Radio0.57
encapsulation dot1Q 57
no ip route-cache
bridge-group 2
bridge-group 2 subscriber-loop-control
bridge-group 2 block-unknown-source
no bridge-group 2 source-learning
no bridge-group 2 unicast-flooding
bridge-group 2 spanning-disabled
the Cisco Unified Wireless IP Phone 7925G is having
Code:
WLAN Driver 1.0.0.54
Firmware ID 4.4.54.1
Load Id is CP7925G-MFG-D.8.LOADS
AP IOS c1100-k9w7-mx.123-7.JA5
However I need to register the device every time when I wanted to make use of it. I wonder that there could be some kind of restriction.
Post here if you are getting the same issue and provide the solution to fix the matter of yours.
Bookmarks