I've done it before. I used to have a special RFU that when FTP'd to the server it would reboot the digital sender. I was hoping someone had more insight in it. Or where i could get it again.
I've done it before. I used to have a special RFU that when FTP'd to the server it would reboot the digital sender. I was hoping someone had more insight in it. Or where i could get it again.
You mean that you want to reset it, so to do so complete the following steps:
- Power Off the Digital Sender.
- Power On the Digital Sender.
- While the product is performing its memory count, hold down the 6 key. When the three status LEDs are illuminated, release the 6 key.
- Press the 3 key four times until the display shows COLD RESET.
- Press the 6 key once to initiate the cold reset. The product will continue its boot sequence.
It is very hard to get information on rebooting HP Digital Sender but you can get some sight and check for yourself if it helps you out from here - http://h20000.www2.hp.com/bizsupport...ctID=c02759054
Bookmarks