hi there.
i have configured a VPN PPTP but i am having issues. I can connect remotely to the VPN tunnel BUT I CANNOT connect to the PC that is connected in the network (i.e., ping or tracert will yield a request time out).
I have attached a PDF diagram of how i did it (hope this make sense). also i made a simple block diagram of my setup.
anyway, base on the attached diagram, this is what i did. from PC-TEST (IP: 10.1.1.200), i have established a connection using VPN, but if I PING or TRACERT the PC-A (IP:10.1.1.100), the result is a request time out.
so my question is, WHY is it that i cannot have a PING or TRACERT success between PC-TEST and PC-A
i would assume that 1723/tcp port is open since i was able to established a VPN connection, but i am not sure if 47/ip port is open, although i have set the VPN passthrough enable in my gateway (Linksys WAG200G).
also, all firewalls are disabled (McAfee firewall and Windows firewall). In the LinkSys WAG200G firewall as well is disabled.
|---------- INTERNET -------------------|
| PC-TEST
Linksys WAG200G
|
|
DLink DIR-130
|
|
PC-A
Hoping for your help. Thanks.
Bookmarks