Motorola 2210-02 Modem

[Jackie]

The Motorola Modem is intended for use in a consumer's home. Ambient temperatures around this product should not exceed 104°F (40°C). It should not be used in locations exposed to outside heat radiation or trapping of its
own heat. The product should have at least one inch of clearance on all sides except the bottom when properly installed and should not be placed inside tightly enclosed spaces unless proper ventilation is provided.

• Windows users: Insert the Motorola Netopia CD into your CDROM drive. The Installation Guide Wizard should start automatically and the Welcome screen should appear to step through your connection installation(s).
  
  • The Motorola Netopia Installation Guide Wizard automates several tasks to get you up and running easily. Run the Wizard on every Windows- based PC that will connect to your network.
    
  • Click the Next button.
    
  • Follow the on-screen instructions to make all of your connections.
    
  
  
  
  
• Locate the Modem near a power source, a DSL wall outlet, and in a location where air can circulate freely around it.
  
• Connect the rounded end of the power supply to the power jack on the back panel of the Modem. Then, plug the power supply into an electrical outlet.
  
  The Power LED should light solid green.
  
• Connect one end of the gray RJ-11 Phone cable to the port labeled “DSL” on the Modem. Connect the other end of the Phone cable to your DSL wall outlet.
  
• Connect one end of the yellow RJ-45 Ethernet cable to the port labeled “Ethernet” on the modem. Connect the other end of the Ethernet cable to the Ethernet port on your PC.
  

[Jackie]

Device Configuration

You can access the Web-based configuration pages at any time as follows:

1. Run a Web browser, such as Firefox, Safari, or Microsoft Internet Explorer, and enter
   
   http://192.168.1.254 in the URL Address text box.
   
   Press Return.
   
   Note:You may be prompted to select your language preference. If prompted, choose a language to continue.
   
2. For security purposes you must create a password for your Gateway. Enter a new password, repeat it, and click the Next button.
   
   You must log in to the Modem. The default User name is admin. Enter the Password you just created. Type these in their respective fields and click OK.
   
3. You will be asked to log in with a User ID and Password.
   The User ID and Password are supplied by your Service Provider. Type these in their respective fields and click the Connect button.
   

[Jackie]

Client Configuration

Your Modem serves Dynamically-assigned IP addresses by default. Be sure to configure each computer connected to your Modem to accept a Dynamically-assigned IP address, commonly referred to as DHCP.

Microsoft Windows:

Step 1. Navigate to the TCP/IP Properties Control Panel.

a. Windows 98, 2000, and ME versions follow a path like this:

Startmenu -> Settings-> Control Panel-> Network(orNetwork andDial-up Connections -> Local Area Connection-> Properties) -> TCP/IP [your_network_card] or Internet Protocol [TCP/IP] -> Properties


b. Windows XP follows a path like this:

Start menu -> Control Panel -> Network and Internet Connections -> Network Connections -> Local Area Connection -> Properties -> Internet Protocol [TCP/IP] -> Properties

Step 2. Select Obtain an IP address automatically.
Step 3. Select Obtain DNS server address automatically, if available.
Step 4. Remove any previously configured Gateways, if available.
Step 5. OK the settings. Restart if prompted.