Hey!
Configuring EIGRP is quite simple..! I've some examples via which you will be able to do it yourself....! If still you have any doubt, do post...!
Setting up EIGRP on a Cisco router using classful IP addressing :
Code:
Router> enable
Router# config terminal
Router(config)# router eigrp ?
<1-65535> Autonomous system number
Router(config)# router eigrp 10
Router(config-router)# network 192.168.0.0
Router(config-router)# end
Setting up EIGRP on a Cisco router using classless IP addressing :
Code:
Router> enable
Router# config terminal
Router(config)# router eigrp 10
Router(config-router)# network 100.20.196.0 ?
A.B.C.D EIGRP wild card bits
<cr>
Router(config-router)# network 100.20.196.0 0.0.15.255
Router(config-router)# no auto-summary
Router(config-router)# end
Make Autonomous system number is same on the routers you connect through EIGRP protocol...! I have use 10 in my examples...!
Simple right? All the best...!
Bookmarks