help: Use two routers simultaneously!

[Adik]

Hello to all,I often follow but this is the first time that I write on the forum.

Hereby I am highlighting the problem: I signed a contract with Tele2 ADSL + phone and I have sent a router to use mandatory for to use the phone, which otherwise would be isolated if not connected to the router, but the only telephone in the wall.

The router is not tele2 WI-FI and I would need to connect with the laptop
around the house.

I managed to set up a joint WI-FI routers for Internet data entering tele2 (also following the recommendations of the forum) but the problem remains for me the phone because the WI-FI router has no outlet for your phone! To which I need is to use both routers, the second of which are like wi fi access point.

If I connect the two cable modem sending the line through that of telephone connection, the second has no WI-FI ADSL line that does not work!
What should I do? How do I send the line from first to second router?


Thanks in Advance!

[Kerwin]

To connect + DEVI phone use to Tele2.
For the second follow this:

1. turn the modem router with integrated modem pure
2. set the parameters for certification under Section Manager PPPoE router (with one WAN port without modem)
3. connect the cable from ETH LAN port of pure modem port WAN router with built-in modem

Requirements for the implementation of this configuration:

1. configuration in the PPPoE ISP
2. or ETH ADSL modem router ETH integrated with adsl modem
3. cable ETH
4. ETH router without integrated ADSL modem

First step: Turn the router with modem MODEM PURE:
Thanks to the protocol RFC 1483 Bridged IP LLC (VPI and VCI = 8 = 35) is always possible to transform into a modem router ETH ETH PURE
This configuration makes transparent the router, and then disable NAT, DHCP and Integrated Firewall.
In section WAN modem \ adsl router select the bridge mode (in some models are the "Pure Bridge Mode")
To be in the configuration of this product after having turned off or shut down the PC, you must force the TCP / IP as DHCP does not come into play more.

Second Step: Configuring client certification with the router WAN port
Even here in the WAN let the voice and we simply PPPoE username and password

Third Step: Connect the two products together

The last step is to connect the modem to the WAN port only the second router

[Adik]

Thanks for your guide,Kerwin.

I"ll try to connect with that guide,If any problem will let you know.

Thanks once again.