Why running in MHz? And I'm getting a blue screen when the PC has been closed for a time, with 4 GB, I had no problem with 8 GB, there were problems, but I cannot see the error actually exists, any ideas? Should increase the voltage to 1.6, is it safe? 4 sticks to burn are quite expensive. My setting is as follows
- Memory Type DDR3
- Size 8192 MBytes
- Channels # Dual
- DRAM Frequency 666.2 MHz
- CAS# Latency (CL) 9 clocks
- RAS# to CAS# Delay (tRCD) 9 clocks
- RAS# Precharge (tRP) 9 clocks
- Cycle Time (tRAS) 24 clocks
- Command Rate (CR) 2T
Bookmarks