Memory problem when 4CoreDual-SATA2

[Gunner]

hi,
i have Motherboard: AsRock 4CoreDual-SATA2,Memory: 2 x 2 gb of DDR2 667 elixir,Problem: if I had both memory inside, then start the computer and reacts to 2 sec after that it stop working. There is also no picture to see. No matter what and no matter which bank of memory. All combinations work.Any recommendations and suggestions are appreciated.

[MattyBoy]

hi,
4CoreDual-SATA2 support Dual Channel DDR / DDRII memory technology,2 x DDR2 DIMM slots, Supports DDRII667/533 non-ECC, un-buffered memory, Maximum capacity of system memory: 2GB,2 x DDR DIMM slots, DDR400/333/266 Supports non-ECC, un-buffered memory.Maximum capacity of system memory: 2GB.

[Baltazar]

Any weird beeps? Onboard video by any chance? Does the initial BIOS post screen start up at all or absolutely no picture at all?

[ciwoc]

Hello, I have exactly the same problem. When I have the 2.0 version it works perfect but after downgrade the bios to 1.9. The same problem when I upgrade the bios from 2.0 to 2.10.
I don't know what has changed in the configuration but I have tried some changes that had no effect. When I put the second 2GB RAM It doesn't start. Black screen.

Any ideas???

[Eldon]

Can be the RAM faulty, have you tried different RAM? or tr this RAM on another system..

[ciwoc]

In my case, my RAM is ok. It worked perfect before the BIOS upgrade.
Yesterday I try some changes on my BIOS. Finally worked, but, after working some time normally, suddenly the system goes down and the same problem arise again.

[Joshua]

Have you tried the memtest : Memtest: Test your memory or you can just make all the bios setting to default .

[ciwoc]

Yes, I have set to default the bios and nothing.
The memory also tested.

[Rudra.J]

Yes, I have set to default the bios and nothing.
The memory also tested.

Best Solution : Wait for some more new updates and till then, use the bios version 2.0