There are 5 Logitech Alert Cameras installed at my place and all of them are working great with no problem. The whole set up is great, video quality is up to the mark also the iPhone app if quite well, but the only thing I hate the most is the motion detection software. I must say that the motion detection software is too worst especially when its been used in outdoor cameras. I am sure your people must have faced the same low quality experience with the motion detection software. Is there anyone who has tried this outdoor at the Logitech with shadows or something like that? I am supposed to set the sensitivity to below 10% on almost all the cameras. There are few of the events that are missed by me but the tons of extra emails and clip recordings are simply cut off but not completely eliminated. Even now I get a continuous recording from those shadows moving through the small pictures about 20 ft away. What I did was tried making small boxes on the detection page but even now I find things that are outside the boxes being triggered as a recording, seems like the custom boxes are not being working. Additionally let me add that all the things are updated perfectly with the latest firmware. I have an e-mail alert that changes to 5 seconds of motion and then send email for every 6 to 7 minutes, but then too I receive number of useless and senseless clips and emails. I would believe that whoever developing this portion in the software and work around in order to get something new. I was forced to purchase some low priced Panasonic netcams for the motion detection email notification that actually works nice and perfectly on the motion triggering emails but somehow misses good picture quality.
Bookmarks