Hitachi HTS543225L9A300 SATA 250GB not working

[Nayanthara]

The HITACHI Model: HTS543225L9A300 SATA 250GB not working this I had recently purchased it. The P/N: 0A57365 MLC: DA2352 no sound, not matter what does not work at the entire. I search near the Power SATA in PCB and originated a Diode D1, a gray block and 2 Fuse F1 and F2 one is missing merely the positions and the additional is present other than infinite ohm. If you have encompassed this disk working and superior shape, please tell me values for this components ohm - Ω. Or additional values, I be able to check in PCB Volts or Ohms.

[Gameli]

You have to basically search your reply on TVS they usually have a tons of information in sequence already completed up for this to facilitate is on their private site beneath their name. You be able to go there and locate data sheets and what ever else you desire on this one. Most of them has a lot of posts their on this problem so this one be supposed to be easy to locate you reply.

[Dannai7]

Any of you encounter several issues in your experience in the either in fact or in contemplation of PCB to damage this components. I imagine in this disk the damage for the reason that the notebook send incorrect volts.

[JErastus]

I am having problem regarding the fuse, for the reason that most of them have 2 in the majority PCB and in this one I have encompassed F1, F2 write in PCB. Additional than, one is missing, through a magnify glass I observe the pins through solder and I not be able to observe the burn or pieces of fuse. The other fuse in the entire scales 200Ω, 2000Ω, 20KΩ, value infinite. D1 I be able to read some Ω. At the same time as I do not have another identical board, I ask your value opinion, or I be able to connect the power and observe the voltages in this part of circuit.

[Faiyaz9]

An overvoltage commencing from a laptop adapter, when applied to an extraneous drive, essentially causes the drive's 12V TVS diode to go short circuit. Additional than that is a different issue. At the same time as your diode is not shorted, then you might be lucky and it could be just presently a issue through the fuse.

[ErikaGeek]

You have to bridge the fuse and power up the board on its own. To this end, you might utilize an extraneous 2.5" USB-IDE adapter. Yes, additional than comparing through a number of large fuse from radios and TV set with the intention of give a fuse of 25 or 35.