Results 1 to 6 of 6

Thread: Troubleshooting mac hardware

  1. #1
    Join Date
    Nov 2009
    Posts
    49

    Troubleshooting mac hardware

    What are the different issues lies on the hardware part of Mac PC. I have a Mac OS x system in which I had tested a 2gb ram which made it reboot again and again. For that I am not able to figure out the issue. How to est difference hardware compatibility on vairuos Mac PC's and laptop. What you suggest for this.

  2. #2
    Join Date
    Apr 2008
    Posts
    2,347

    Re: Troubleshooting mac hardware

    Apple deliberates most interior individual hardware troubleshooting to be not recommended. Do so only at your individual risk! Be sure to release anybody static by moving a secure element ground situation after opening a Mac. SIMM contacts might be cleaned by means of a pencil eraser and reseated. The tiny synthetic clip ears (particularly on older SIMM sockets) are very, very delicate.

  3. #3
    Join Date
    May 2008
    Posts
    1,822

    Re: Troubleshooting mac hardware

    If you be uncertain at this point, pay no attention to this suggestion. A safer move toward is to test the remembrance constantly with a ram diagnostic agenda like Snooper or RAMometer (sys 7) for number of hours. If you feel contented removing SIMMs, you can additional completely confirm third-party remembrance is not faulty by selectively removing/swapping banks of remembrance. If a sad Mac convention shows up on the screen immediately below the icon, use it to place a bad module.

  4. #4
    Join Date
    May 2008
    Posts
    1,812

    Re: Troubleshooting mac hardware

    On Macs by means of moreover 72 pin SIMMs or 168 pin DIMMs, you can take away the memory components one at a time slightly than in banks. For a Mac with an accumulation SIMM or board, you can try resolutely reseating, removing or replacing it as desired. This can make simpler or easy your troubleshooting. If you have third party remembrance on a PowerMac, ask your manufacture if you may have installed a mismatched kind of amalgamated RAM by mistake.

  5. #5
    Join Date
    Nov 2005
    Posts
    2,327

    Re: Troubleshooting mac hardware

    If you are working on the Power Mac with a L2 RAM accumulation card, you can try to take away it to see if the mistake 11 rate goes down or basically test it with diagnostic software like TechTool Pro. Terrible on PowerBook Street from New machinery is a freeware submission that was written to remove inaccurate memory modules in PowerBook 165c and 180c computers. More than a few companies sold memory which added Wait-States to the process of the PowerBooks. "Terrible on PowerBook Street" allowed Users to with no trouble to test their notebooks and conclude if they had been sold inaccurate memory.

  6. #6
    Join Date
    Nov 2005
    Posts
    2,483

    Re: Troubleshooting mac hardware

    When you are going start your system, if you do not even listen to the fan motor or the power cuts out without warning, you may desire to make sure or ensure your battery(s). The premature Mac II series have batteries that are soldered in, but additional present models use a battery holder. An absorbent dead lithium battery can critically injure a mother board with acid, so it be supposed to be replaced punctually. If a cell noticeable 3 V or 3.6 V tests below 3.3 V, it is almost certainly gone or well on the way (Apple says 3.0 to the public and 3.2 to its service people).

Similar Threads

  1. Use Apple Hardware Test to test hardware
    By Proserpine in forum Portable Devices
    Replies: 6
    Last Post: 15-11-2010, 08:50 AM
  2. Troubleshooting ICQ on MAC
    By Aadi007 in forum Technology & Internet
    Replies: 5
    Last Post: 13-02-2010, 01:48 PM
  3. How to remove hardware tab from hardware properties
    By Dwarner in forum Customize Desktop
    Replies: 3
    Last Post: 24-04-2009, 12:32 PM
  4. Ram Troubleshooting
    By monsitj in forum Hardware Peripherals
    Replies: 2
    Last Post: 30-07-2008, 03:59 PM
  5. Migrating Windows 2003 server from old hardware to new hardware
    By Zaur Bahramov in forum Windows Server Help
    Replies: 9
    Last Post: 03-06-2008, 04:22 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,714,020,365.47320 seconds with 17 queries