HP Printer Error Code 0xc18a0001

[savio]

Hi,

I have HP Photosmart C6280 printer, as in the subject gives Error Code 0xc18a0001. Starts normally, but when you try to print above indicates. The HP support I got the information that it is a memory error. I have tried RESET (Holding the Power button press the power plug). Obviously did not help! On the Internet, I found something on another reset in the event of an error, but this was another model Photosmart, so I can find the solution for my HP Photosmart model.

[JIII]

Try the following steps to remove HP Printer Error Code 0xc18a0001 :

1. Without turning off the printer, unplug the USB cable.
2. Remove the cartridges.
3. Wait until the message "Insert cartridge" appears.
4. Unplug the power cord.
5. Wait 60 seconds.
6. Reconnect the power cable. If the printer does not turn on automatically, press "On button".
7. Reinsert the cartridges and close the lid.
8. If the printer has a page of calibration accept.
9. Reconnect the USB cable and remake an impression.
10. If the problem persists, the machine must be repaired.

[CoModO]

Turn the printer on the network. remove the right cover. Unplug the cable from the motherboard J7 (closest to the front wall). Turn the printer on and wait error 0xc19a0002. Turn off the printer, insert the cable, turn the printer on and wait the end of the initialization of the printing system. If the error stills comes, Unplug the printer and then simultaneously pressing the buttons "Help" and "Ok" reconnect.

[HellBoy21]

This may be your document to print the result of larger capacity, resulting in the printer memory, unable to complete the print command. Here's the solution :

* Unplug the power cord.
* Press and hold the button "On / Off" or "on / off" for a minute.
* Reconnect the power cable.

[JIII]

Solution for Error Code 0xc18a0001 :

* Turn the printer and wait until you receive the error message.
* Simultaneously press the keys "9" and "#" printer.
* While holding the button down, unplug the power cord from the unit.
* Wait a few seconds.
* Still holding the button down, reconnect the cable and turn on the printer.
* Release the buttons.

[Simpson]

HP machines have a small problem with BIOS programs, I recommend you to Firmware to upgrade the software, as long as the software will start running once the to the printer to write a new BIOS, when the computer display Firmware upgrade is complete, the OK, and the software upgrade solved this my boot time problem with model HP8238, and frequently with machine ink system error problem.