mount Corsair H100 CPU Cooler in Antec 1100 case

[Asaph]

I have using Antec Eleven Hundred case for my computer system. I was thinking of getting a CPU cooler for this that I can use in this cabinet. So I bought the Corsair H100 CPU Cooler but I dont know how do I mount it in this case? Can anyone give me some tips like where should I mount this Corsair H100 cooler on Antec 1100 case? Should I just attach it at the back side inside the case? Thanks

[Omari]

I have found that the best place to fit Corsair H100 CPU Cooler in Antec 1100 case would be the space given for the 240mm radiator at the top that is used by the two 120mm internal intake fan slots, you can simply install it there. This location seems to be quite fine and you might have to get some extra air getting to the RAD although everything seems proper.

[Abbie]

The Corsair H100 will fit in the Antec Eleven Hundred case but it should be a little tight. But the issue will be that you will not get the option for push & pull for this case and there might be some interference with the motherboard and the RAM. You will be also able to use the CPU cooler with a single set of fans if it is 500mm of greater size.

[Brooks]

Well, for your computer case, you should get 2 front case fans blowing ait into the case and also get the side fans. This will make the top and rear fans in the case an a exhaust fans that will blow hot air outside of the case. In my personal opinion I dont think that H100 is a good cooler for the case that you are using since Antec 1100 doesnt have good spot for the cooler.