I am suddenly getting a pop up error when I start-up - saying CLED error. No
more information. How do I solve this?
I am suddenly getting a pop up error when I start-up - saying CLED error. No
more information. How do I solve this?
Hi there,
Which operating system are you using?
By nau chance do you have Steinberg Cubase installed?
Best regards,
Michel Denie
"richtea" <richtea@discussions.microsoft.com> wrote in message
news:917E518C-0BA1-44B3-AC1B-DD179078CD1E@microsoft.com...
>I am suddenly getting a pop up error when I start-up - saying CLED error.
>No
> more information. How do I solve this?
Hi,
Thanks for your response. Yes, I do indeed have Cubase SX3 on there. I'd be
grateful for any advice.
RT
"realcestmoi" wrote:
> Hi there,
>
> Which operating system are you using?
>
> By nau chance do you have Steinberg Cubase installed?
>
> Best regards,
> Michel Denie
>
> "richtea" <richtea@discussions.microsoft.com> wrote in message
> news:917E518C-0BA1-44B3-AC1B-DD179078CD1E@microsoft.com...
> >I am suddenly getting a pop up error when I start-up - saying CLED error.
> >No
> > more information. How do I solve this?
>
>
>
Hi there,
Usually this error occurs when Syncrosoft-Emu (H2O) is installed twice, to
bypass the problem make ctr alt delete which willl bring up the taskmanager,
click aplications on top of the screen and choose new tasks type in
msconfig and enter. In the msconfig window click the startup botton.
Disable (unmark) cledx.exe.click apply and okay.
Reboot to check that your problem is gone.
When you start cubase you will have to start true emu manually to startup
cubase.
Let me know if this solved your problem?
Hello,
Thank you so much for your help.
I followed your very clear intructions, and re-booted. The CLED error window
had gone, but was replaced by a System Configuration Utility message, telling
me that the Syst. config. utility is currently in diagnostic or selective
start-up mode, and that I should choose 'normal start-up mode' and undo
changes I made in the S.C.U.
What would you advise?
I made no changes and cancelled the message, but it will continue to show me
it each time I boot-up.
thank you again,
RT
Hi there,
Just keep the changes so tell the system configuaration utillity to ignore
it and not show again.
Best regards,
Michel Denie
Thanx ur previous reply helped out gr8tly...I'm having problems on installing my hypersonic 2.O when I get 2 some point some pop up notification comes up which reads H20 driver has already been detected in my system and asks if I want 2 reinstallit (driver) . After clicking yes the CLED error comes up again and it writes installation failed I was wondering where I could find d previous H20 driver and uninstall it so my current h20 driver can b properly installed.
Bookmarks