How to use PQmagic for ghost

[Langward]

Hi all,

District Master PQMAGIC and restore wizard Ghost is our most used adjustments, backup and recovery partition software, they have been for us to save the data under the premise of the capacity to change the number of partitions, but also savings in re-zoning and reload the system time .However, I have an issue because of the misuse of these two software systems, resulting in paralysis, partition or even the whole Hard Data loss. I want to now that How to use PQmagic for ghost.

[Glenny]

In the graphical user interface PQmagic, Windows automatically loads itself, almost all of Hardware. The driver, of course, also includes a mouse-driven, usually do not have to worry about the circumstances under which this issue. However, in DOS mode, a lot of people do not own to configure CONFIG.SYS and AUTOEXEC.BAT, which is not automatically loaded Mouse The DOS driver, then run under pure DOS when these two software, you have to completely rely on Keyboard Operational control.

[JonathanD]

Some people in order to speed up disk access speed, on the Windows, DOS window to GHOST and the PQ operation. This speed is fast point, but may cause a lot of trouble, for example, may inadvertently operate on C disk, if it is backed up, then some of the documents in a read-write protection is unable to continue; if it is to restore or change the operation of the primary partition, then , the system will immediately Illegal Operation even paralysis. In addition, because Windows in a graphical interface will be created in each district in a lot of temporary files, including the page file is part of the temporary files, so that the disk of debris generated a lot of backup in this state is not very satisfactory results Therefore, I suggest you try not to carry out in a graphical interface Ghost or PQ operation. All the best.

[Sam.D]

As PQMAGIC change the partition to ensure the safety of your original data, so if the original partition to the substantial data, it will first backup to copy data to another partition of the temporary directory, but also changing the capacity or time to create a new partition , to partition scan detection; Ghost Backup and recovery but also a lot of data copying - these two operations should be carried out large amounts of data transfer, so the disk speed is more important, pay attention to open the disk DMA transfer mode, if it is in DOS mode, I remember loading SMARTDRV then carried out the better. All the best.

[Raine]

Especially PQMAGIC, if the partition larger capacity and do not load these high-speed cache, time-consuming of these operations is very long. The longer the operation is relatively higher risk, if the half-way stops responding or crashes experienced any power failures, not only the data will be lost, but also may cause Hardware damage. Check and reply.

[Eric B]

When using the PQmagic partition, we must remember that you choose to see the partition format, volume, the default state is always FAT, if the partition of more than 2GB, should choose FAT32 or NTFS format; NTFS boot disk can not be general, and 9X system identification, be careful not to select wrong. In addition, if it is to be installed in the partition OS used to start, and remember that should the partition set to active. Many people at the forum Posted child request for help, said the district lost, Hard reduction in what capacity, and very likely did not pay attention to these basic factors that result. All the best.