Today Windows XP is used by a large number of people, often used as the system presents us with some typical errors and blue screens that maybe he has gone to many, but many do not know why this error even though the same error tells us the problem. In this post one can see and know why these errors occur.
Stop 0x0000000A (IRQ_NOT_LESS_OR_EQUAL)
Causes: Drivers Incompatible
Explanation: This error indicates that a kernel-mode process or driver attempted to access a memory address to which you do not have permits. Typically occurs because the code is a pointer that refers to a section of memory that does not correspond to the process. This causes a violation of the separation process in Windows and a stop to avoid overwriting code or data from other processes.
Stop Ox0000001E (KMODE_EXCEPTION_NOT_HANDLED)
Explanation: A driver or program has requested a page from an invalid memory address.
Stop 0x00000077 (KERNEL_STACK_INPAGE_ERROR)
Cause: faulty Sector in the swap file, IDE cables defective virus
Explanation: A page report requested by the Kernel has not been able to be read from the swap file into RAM
Stop 0x0000007B (INACCESSIBLE_BOOT_DEVICE)
Cause: Change of controller, change disk to another PC, virus
Explanation: Windows can not find the partition where are your files.
Stop 0x0000007E (SYSTEM_THREAD_EXCEPTION_NOT_HANDLED)
Cause: Drivers or incompatible software, incompatible BIOS, incompatible hardware
Explanation: A process of the system has generated an exception that has not been processed by the handler of exceptions. If the error occurs when you connect a USB device, it's because the USB bus is being used at 100% already. Connect the device to another controller or the USB device before connecting again. If the error is in Kbdclass.sys, is caused by the utility Logitech iTouch. Download the latest version.
Stop 0x0000007F (UNEXPECTED_KERNEL_MODE_TRAP)
Cause: faulty hardware, usually RAM or motherboard, incompatible software.
Explanation: A Kernel or driver has been found that there is not enough space on the stack to perform the operation that was intended. One of the most frequent causes is Norton Antivirus.
Stop 0x0000008E (KERNEL_MODE_EXCEPTION_NOT_HANDLED)
Cause: Hardware, drivers or BIOS incompatible. The most usual is defective RAM or Nvidia drivers.
Explanation: A Kernel has been an exception not processed by the handler of exceptions.
Stop 0x0000009F (DRIVER_POWER_STATE_FAILURE)
Cause: Driver badly done, for overclocking, voltages
Explanation: The cause is the same as the 0x0000000A error, but on this occasion is known to be a safe driver.
Stop 0x00000024 (NTFS_FILE_SYSTEM)
Cause: Hard disk damaged cables in bad shape, damaged file system
Explanation: Windows can not access the NTFS partition where are your files.
Stop 0x00000050 (PAGE_FAULT_IN_NONPAGED_AREA)
Cause: Drivers incompatible software incompatible, faulty RAM, defective card
Stop 0x000000EA (THREAD_STUCK_IN_DEVICE_DRIVER)
Cause: Driver, typically that of the graphics card, wrong
Explanation: The driver has entered into an endless cycle, repeating the same instructions over and over again.
Stop 0x000000ED (UNMOUNTABLE_BOOT_VOLUME)
Cause: Change of plaque or controller, IDE cables defective or inadequate, changes in the connection of the discs.
Explanation: Windows can not access the partition where are your files.
Stop 0xc0000218 (UNKNOWN_HARD_ERROR)
Cause: Files Registration damaged or deleted. Faulty RAM.
Explanation: Windows can not load because of the registry files are missing or damaged.
Stop 0xC000021A (STATUS_SYSTEM_PROCESS_TERMINATED)
Cause: Software or incompatible drivers
Explanation: A user-mode subsystem (CSRSS or WinLogon for example) has had serious mistake.
Stop 0xC0000221 (STATUS_IMAGE_CHECKSUM_MISMATCH)
Cause: Files modified, errors in the disk access, defective RAM.
Explanation: To verify that the files that load when Windows starts have not been modified, it calculates a checksum at the time loading and compared with the stored there. If you are not equal, it generates this error.
Reply With Quote
Bookmarks