Hello
I have many problems with the simulation software omnet + +, I start myself by trying to test a small sample to get an idea about the execution.
For that I wrote back in the commands:
opp_nmakemake
For Responses I have the following:
opp_nmakemake: use-f to force overwriting exiting Makefile.vc
then I run the command:
NMAKE-f Makefile.vc
as expected NMAKE is not recognized as internal command.
what is the solution for this problem and what is needed for omnet configuration or installation of a tool (I have already installed VisualC + + toolkit)
thank you for any help and advice.
Bookmarks