PC freezes using 1333 MHz Kingmax DDR3 ram on Gigabyte GA-G41M-Combo motherboard

I noticed that my RAM (DDR3 1333Mhz Kingmax 2gig 2x) 1065 / 1066 MHz work when I tartan into the Easy Tune 6 and in the bios. 1333 will have a growth x4C 3.2b 2.4b x4A not only which do not add up to 1333, only 266 MHz and 200 MHz, but my pc freezes well, the graphics card does not function or the program does not respond. I am using Gigabyte board as mentioned and Windows 7 OS on my system. Help me solve this hitch.

It may be due to residual charge storage. Almost the whole system faces the issue of storage of residual charge. Residual charge is stored near the RAM chips for the laptop. If the voltage of the charge accrue near the RAM chips is that the system will not be competent to access the system RAM. Therefore, you must remove the residual charge. To eradicate the residual charge, turn off the computer and disconnect AC power. Remove the RAM, clean and reconnect to check.

Then you are supposed to make an effort to clear the CMOS. This is crucial to erase the memory of the motherboard and BIOS settings to their factory state. Yes, I assume these values are incorrect BIOS settings for the rationale that the system freezes and gives back this issue, but also endeavor to load the BIOS default system and save the settings. I seem onward that this solution is expected to work and be of aid for you to solve your freezing issue.

Well, I do numerous things for you to obtain the desired speed of system RAM. First out of the frequency of ADRs in the automatic mode, you can do this from the BIOS. You mentioned that some programs do not work, and even some games on it to change the multiplier x4C to let it work. Or you can try putting it in x4A multiplier. The frequency can be reduced to 333/266/200 to avoid the problems you are getting.

You have to check the attunity of the RAM modules on the motherboard. Then go to that website and come across the appropriate settings meant for the RAM. I believe the time is 9-9-9-24 or possibly this may be 7-7-7-24. The multiplier is x4A only seems to work. The other option I see is to revise the BIOS to a newer firmware obtainable for your card, as this will restore the supreme settings intended for your motherboard.

I advise you not see a rev GA-G41M-combo. 1.4 only looks rev. 1.3 on the Gigabyte website. If this is the rev. 1.3 in 1066 is the evasion setting only through overclocking u can get 1333 MHz? You can use the card of DDR2 and DDR3? Some have two combos G41M-DIMM DDR2 and DDR3 DIMMs two. The G41 chipset to use only 800, 1066 or 1333 through oc. 3.33bo 4.00b No, because 1066 is the default for the G41 chipset. If you use the 1333 SPD memory with XMP profile is overclocking the CPU.