Unable Browse Internet After System Cleanup
I recently had a sysytem cleanup and it went all successfully. There was a tremendous improvement regarding the performance of the ssytem. But i am facing a strange problem regarding my internet access. As after system clean up, i am not able to browse internet. I tried very much but not able access internet. Please provide some opinion regarding this
Your opinion will be apprciated
Re: Unable Browse Internet After System Cleanup
Have you tried r-clicking your network, selecting Properties, and uninstalling and reinstalling Internet Protocol (TCP/IP)?
IPCONFIG /ALL
Right click in the command window and choose Select All, then hit Enter.
Paste the results in a message here.
Re: Unable Browse Internet After System Cleanup
1 st of all go to safe mode with n/w and try connecting to the internet from there remember to logg in as the administrator
u can also try this boot to the normal mode go to start run and type in cmd in the command prompt window type "ipconfig /all" see what is the ip address make sure it is not 0.0.0.0 or it does not start with 129.
than type"ipconfig /release" press enter and than type "ipconfig /renew" hit enter than type "ipconfig /flushdns" and hit enter once these steps are over
go to start control panel and open internet options there delete files and clear cookies clear histroy
go to the advanced tab and uncheck the option ENABLE THIRD PARTY BROWSER EXTENSIONS
click on apply and than ok do msconfig and clear the start up
than try connecting and tell me wether that works
Re: Unable Browse Internet After System Cleanup
try installing ie again
go to serch serch for ie.inf rt click on the 1st serch result and click on install also insert the windows xp cd and when it asks for the drive to check in change the drive letter to the drive letter of the cd drive
u already tried doing the windows repair rt if the repair for any reason was unsuccessful try doing a systerm restore
Re: Unable Browse Internet After System Cleanup
Sounds as though your default gateway is being changed to the NIC when it is installed. Compare the outputs from the /sbin/route command before and after inserting the NIC.You may need to delete one or add another for your dial-up.
What exactly is the contents of /etc/resolv.conf? Does it change depending on whether you have the NIC installed? WHen you say you can ping your dialup internet, is that via IP address or FQDN?
Re: Unable Browse Internet After System Cleanup
Hi,,
When you do the cleanup, noting should be change, and if you r stll not working .....go to file then check if you working off line !!! so you have to remove the check sign
Please I want ask how is your dial up speed, r you happy whit it !!!
Y you don’t use DSL !! its more expensive then dial up charges,!!
Hope you fund the solution soon
Thanks and take care