Problem with ATI Radeon HD 4350
hi,
i have old Dell PC which does not need a AGP and PCI-E slot on the Motherboard. Only Pci-E x1 and 2 PCI slots.The card works flawlessly but OC-like tools. ATi Tool does not take the new clock rates. In Atitool, the clock rates to 0 (default is 600/400) and if I for example. at 650/450.Power Strip beeps when simply take over and put it back again to 600/400. My basic assumption that the clock rates are not properly recognized by the tools.Any recommendations and suggestions are appreciated.
Re: Problem with ATI Radeon HD 4350
hi,
What have you done exactly? On the image I see nothing special?
Re: Problem with ATI Radeon HD 4350
The disadvantage is that the graphics card now only can transmit data on a single lane. Pci-E x1 slot is actually not designed for graphics cards. normal Pci-E x16 / 8 slot is much longer.
Re: Problem with ATI Radeon HD 4350
According to Chip Boards with nForce2, nForce3 and nForce4 chipsets Under the same user has AtiTool with the Radeon 9200 in the pci-bus.Just the new clock rates in the bios flash tool instead to use? 650/450 works so flawlessly, according to CCC. If I get into the 650/450 bios flash would then Ati Overdrive is not supported by this clock out and clock up further? If so, I could then find the maximum safe?