I get the White screen at start up of Sony Vaio VGN-FW11E

[KaIilAshhh]

Sponsored Links

I have purchased the new sony vaio VGN-FW11E laptop two months ago. The working of the device is very fine till the last week. But after that I faced some serious problem. The problem is when I try to start up my PC then it does not boot in the normal way. The display give me a Whitish screen and that’s why I cant see anything. But after sometime when the system gets warm up then reboot give me the proper working. And the system working in the normal mode. Thereafter I cannot get the white screen, no matter how many times I restart later the working is proper. But when system gets cold then the problem raised again and again. Can anyone know the solution for this. Please help me to solve this problem.

[Kickapoo]

I read your problem and I come to know that you have a problem related to hardware only. And the problem may be in the LCD screen of your device. I think the LCD backlight is not working properly. This is the main reason for this kind of problem. I am giving you a suggestion to take your device to a store of specialist of the laptop and then you have to test it with new LCD. This is the simplest way to solve your problem. I am not sure about the solution because I never had this kind of problem. But you can try it for better experience.

[Cruzz]

As per your description I think your problem is raised due to fault in the LCD screen. This problem mostly found in the Sony laptop users but it cannot get the proper solution for solving it. I can give you some idea to solve this problem. This solution may or may not be applicable to your system. But you have to try it. The solution is that you can try to connect your device to an external LCD with use of of some cabling equipments. This can be useful for some time. But this will also create a difficulty to switch between the LCD without the built in one.

[Odalis]

According to your description the symptoms are similar to inverter failure and backlight lamp failure. I think this problem may relate to one of this reason. So you have to check out your inverter as well as your backlight lamp. The inverter failure is most often rather than backlight lamp failure. So I give you an advice that you should check the inverter first. If this technique cannot solve your problem then please show the device to the specialist for more support. I hope this will work for you.

[Abenaki]

The problem sounds like the hardware failure and not the software problem. I can give you some suggestions to solve your problem . I don’t sure about the result but don’t worry it does not affect your system. First you have to try to run the system just on the AC adaptor with the no battery install in the system. You can also try to reseating the memory for your system. Suppose this not works then you have to check out your motherboard for better use. Hope this will give you some idea to solve your problem. Thank you.

[Beothuk]

I don’t have enough idea why this problem raised in booting. But I can give you some tricks to find out the answer. To solve your problem you have to remove all the memory from you system. And then check out whether the system any beep codes at start up or not. This can definitely reduce the effect of the problem from your system. Because sometime hard drives raised an error for this kind of condition (when memory gets full). I think this will help you solve your problem.

[Huron]

You did not give the proper configuration of your system so I cannot get the whole idea about the problem. So please give me exact configuration then I will provide you the perfect solution. Even though I give you some suggestion for that. Please check out the inverter and the backlight lamp. Then try to remove the data from the disk. If this not works then please take a help from nearer Sony customer care. Hope this might help you. Thank you.