Open and clean the T2010 display

[Tamas]

If I have encompassed a T5010 by means of multi-touch (dual digitizer) and a T900 without, is it probable to swap the screens, consequently giving the T5010 the active digitizer merely and the T900 the dual digitizer by means of multi-touch. Most excellent is you eliminate the bottom plate of together tablets to take a look at the connectors, if they look indistinguishable, it's probable that you be able to swap together screens containing frame. For the reason that the Dual Digitizer has two digitizers, one attached to the back of the display (pen), one as the defensive front glass cover (finger), you would not be capable to 'just' swap the panel alone. What should be done in this case.

[Antonio1]

In conclusion, subsequent to 8 months, I determined to eliminate the dust connecting the display and the front cover. I completed a lot of pictures which describe and demonstrate you what you have to do and how easy it is first you have to shut down your tablet, eliminate the AC-adapter, and after that you have to remove the battery, rotate your display and position it in tablet mode. Then they have to eliminate the 8 rubber bumper by means of a diminutive flat screwdriver. Try to keep away from touching the adhesive side by means of your fingers, else they might get dirty and determine to not glue correctly later.

[Carlos16]

You have to utilize a number of plastic or your finger nails to unlock the clips. Immediately slide by means of your finger nail along the gap connecting the front and back cover of the display, approximately the whole display. You would not have to utilize much force the clips determine to open easily and by means of less force. It’s impracticable to break such a clip subsequent to you have completed that, eliminate the front cover and clean your display. In addition try to eliminate the entire the dust from the frame, circuit cards and front cover.

[Deepest BLUE]

It remarkable how the T4220 and the T2010 display parts is different. On the right side of the display (in exchangeable mode) for the T4220, there's this large plastic attachment that has a circuit board in it, which I consider is the wireless antenna. I have not opened a T2010 series Tablet PC display congregation, additional than from reading Frank's post, it come into view that the T2010 is easier to open the display. I encompass a heck of a time trying to open the first couple of tabs to open the display up. Then the entire in excess of again it might be immediately that the dissimilarity connecting an LED (T2010) and a CCFL (T4220) display.

[Madhuparna]

You must in addition anxiety that when cleaning the real display, do not be appropriate too much pressure on it, immediately be gentle by means of the wiping of dust. I might suspect that the dust is coming from the diminutive gap connecting the display chassis and the fingerprint reader. Contrast to the T4220, the T2010 has immediately one entry point of particulates. The T4220 has that quarter in the pen slot (where the pen buttons rest) and where the tip goes into, the fingerprint reader, and the LED position display area.

[Wappinger]

The circuit boards were occupied of dust, that revenue dust is in the display case and you be not able to do no matter which against this. Additional than if you give the impression of being at the pictures where the display case is opened you be able to observe a black rubber stripe approximately the silver display borders, which is intermittent at the edges. I do not be familiar with it other than I believe that dust comes from side to side this points to the display. Perhaps you be able to fill this gaps by means of some rubber, perhaps this helps. Additional than it's in addition possible that Fujitsu made this gaps intentional to permit a small air circulation and venting.

[Susquehannock]

Would I immediately switch out the complete thing or would I necessitate obtaining apart the screen frame and taking out immediately the digitizer element. I imagine this method I am able to maintain the upgraded 2.0 mp web cam, additional than if it is much easier to basically replace the who unit at the hinge, I determine to gladly take the 1.3mp webcam. Is the digitizer basically a USB type thing that plugs into the motherboard.