How to Remove Motorala Razr V3 Battery

[avit]

Sponsored Links

Hi,

I have a Motorola RAZR V3, from the last few days the battery is dead, so of course I went to load and no charge, then it will not turn at all. I contacted the AT & T and have recommended that people try to get a new battery for it, because we believe that the battery is the problem. So how do I remove or change the Motorala Razr V3 Battery ?

Thanks you very much.

[SergioSantos]

To remove Motorala Razr V3 battery, press the top cover (located on the top of the phone) this way you move away from the phone. Consult your manufacturer's manual, if not go to your nearest authorized to store and get help. remember that there are parts in this sensitive area which can suffer permanent damage.

[PreatORiAn]

You can change Motorala Razr V3 Battery by just removing the back cover by pressing the silver button down hard then press the top of the battery down then pull it back, In the middle of the battery there is a small slot just put your finger or the corner of the door and push up and then insert the new battery.

[TX-Snakebyte]

Follow the below steps, to Remove Motorala Razr V3 Battery :

1. Make sure the phone is off.

2. Press and hold in the battery door as shown to release the latch housing to the batter.

3. Carefully rotate the battery cover and lift up the phone completely off and adjust in the face.

4. Push in the bottom of the phone and lift the end of the battery first, is free and you can remove the phone.

5. To replace, align the battery with the battery compartment so that the holder
contacts of the battery matches the battery contacts in the phone.

6. Insert the battery, the first face at an angle in the battery compartment and press down followed by the opposite edge of the battery.

7. Insert the bottom edge of the battery cover on the rear housing
then press the top edge of the cover down and snap into place and the phone returns to its original state.