Go Back   TechArena Community > Hardware > Overclocking & Computer Modification
Become a Member!
Forgot your username/password?
Tags Active Topics RSS Search Mark Forums Read

Sponsored Links



GTX 470 and cooling

Overclocking & Computer Modification


Reply
 
Thread Tools Search this Thread
  #1  
Old 01-05-2010
Member
 
Join Date: Apr 2010
Posts: 84
GTX 470 and cooling
  

Hi users,

I buying one new GeForce GTX 470 cards. GeForce GTX 470 have been very hot very noisy, but on the overclockers do not care for them, limit the impact of the excitement is the most important, today we look at the GTX 470 on the cooperation of the original radiator can be super to to what extent. Can any body know the cooling ideas of GTX 470. Please suggest. All the best.

Reply With Quote
  #2  
Old 01-05-2010
Member
 
Join Date: May 2008
Posts: 666
GTX 470 and cooling

You need to use overclocking tools available are very few, fortunately EVGA provides a new internal test version of EVGA Precision, but also run into setbacks. Start the software, not many options, but the core frequency and fan speed are gray are not even adjustable. Shader units in the regulation of frequency, while the core frequency of surprised to begin to change, while open GPU-Z can confirm that the two frequencies do change in sync. All the best.
__________________
Bayonetta Preview
Reply With Quote
  #3  
Old 01-05-2010
Member
 
Join Date: Dec 2007
Posts: 1,592
Re: GTX 470 and cooling

You need to use HR-03 GTX HR-03 GT and radiator on, so that it can support the GF100 Series graphics cards. Currently, the third-party support for GeForce GTX 480/GTX 470 of the radiator is still very small, given the tremendous heat of new graphics cards, third-party cooler will accomplish much. But did not specify the new buckle ride out a specific release date, only said "soon", estimated at the end should be able to launch. Check and reply.
Reply With Quote
  #4  
Old 01-05-2010
Member
 
Join Date: Dec 2007
Posts: 994
GTX 470 and cooling

Power problem is one of the reasons for heating. Running speed in GHz chip consumes enormous energy, the designer must reduce the transistor voltage, in order to avoid burn out electronic components. However, once the voltage is low, the chip pulse signal resulting weakening may result in signal loss. Also, if voltage is less than 1 volt, could lead to electronic components can not be opened due to insufficient voltage, the transistor components from the nearby "steal" power, resulting in chip voltage slightly. I believes that as long as the control voltage can be cleverly solved the problem.
Reply With Quote
  #5  
Old 01-05-2010
Member
 
Join Date: Jan 2006
Posts: 830
GTX 470 and cooling

Radiator is a heating element to speed up heat dissipation device to measure a good or bad radiator two: heat and mute.Computer extensive use of integrated circuit components. Well-known, high temperature is IC. The role of the radiator is to these Heat absorption, and then diverge to the chassis or Chassis addition, to ensure the normal temperature computer components. Most parts of the radiator and heat through surface contact, absorb heat, then heat transfer through a variety of ways to the distant, such as the chassis of the air, and then spread to the chassis to the hot air outside the chassis, the completion of the computer's cooling. All the best.
Reply With Quote
  #6  
Old 03-05-2010
Member
 
Join Date: May 2006
Posts: 973
GTX 470 and cooling

You need to re-integrate the cpu with new clean thermal paste. after that update the BIOS of the board. If not, fixed, try the system out of the chassis as a test. Make sure that you have a good PSU as well. Best of luck.
__________________
Searching the forums can help you to find your answers more quickly
Reply With Quote
  #7  
Old 04-05-2010
Member
 
Join Date: May 2008
Posts: 651
GTX 470 and cooling

If the temperature of interface material is not installed properly, may result in processor overheating. Follow the manufacturer's instructions carefully to ensure that the temperature interface materials and grain processors, part of the exposed and the temperature of notebook solution for connecting piece of metal, have 100% exposure. In addition, the temperature must not touch interface materials, because any foreign material (such as the skin secretion of oil or other chemicals) are likely to reduce the temperature of the processor and interface contacts between the connecting piece of metal effect.
Reply With Quote
Reply

  TechArena Community > Hardware > Overclocking & Computer Modification
Tags: , , , , , ,



Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar Threads for: "GTX 470 and cooling"
Thread Thread Starter Forum Replies Last Post
Water Cooling looks too complicated to setup compared to air cooling --MasseySian-- Overclocking & Computer Modification 8 14-07-2012 05:20 PM
Power Management Passive cooling vs Active cooling Illinois Portable Devices 5 17-08-2010 06:30 AM
Artic Cooling Freezer Extreme Vs Artic Cooling Freezer 7 Pro Andrzej Overclocking & Computer Modification 12 07-07-2009 11:39 AM
Air Cooling / Cooling laptop Tomthegreat Overclocking & Computer Modification 3 21-04-2009 07:17 PM
Changing from air cooling to water cooling Saaarc Overclocking & Computer Modification 6 17-04-2009 10:08 PM


All times are GMT +5.5. The time now is 01:51 PM.